Testing Machines

Rockwell Hardness Tester. Suitable for carrying out Rockwell Hardness Tests on Metals and Alloys of all kinds. Hard or soft. from Carbides to Plastic covers. Standard Scales. A. B. C, B. E. F. G. FE and K also additional Scales L. M,P,R.S and V. 

• Main spindle is guided in HRD/ Ground/ Lapped bush with friction compensator arrangement. These are fully enclosed machines with Cast-Iron body and the weights applied can not he seen from outside. The mechanism inside the machine is thus protected from din and dust. The basic system is one of weights and levers. The load under Hydraulic Dash-Pot is adjustable. Time control is applied by standardized weights through a levers on knife edged fulcrum and a knife edge free floating frictionless plunger system. All knife edges and levers in this system are thoroughly hardened and lapped. which is a precision point and it gives long life to these machines. It is inspected by high precision optical instruments. 

• Quick lifting and release attachment for Elevating Screw most suitable for batch production testing. 
• Gear Testing fixture. 
• Jack rest for long Jobs floor Stand. 
• Gooseneck adopters for testing inside hardness of Tubes and Bushes etc, 
• Gooseneck Anvils for Testing outer hard-ness of Tubes and Bushes etc. 
• Cylindron Anvil for Testing jobs 20 to 200 mm. diameter. 
• Shallow Vee Anvil for testing small diameter pins and rods. 
• Eye Ball Anvils for Testing Small tapered jobs. 
• Spot Anvil. 
• Vee 70 mm. dia for jobs 10 to 80 mm. dia. 
• Flat Anvil 200mm dia. 
• Flat Anvil 15mm dia.. 
• Testing Table 240mm. dia with T Slot for Testing odd shapes 
• Steel Ball Indentors and Extra balls 1/8 and''/ dia.